![kerosun monitor 30 manual kerosun monitor 30 manual](https://toyotomiusa.com/wp-content/uploads/2021/08/owner-manuals-heat-convectors.jpg)
Be sure that you contact a professional repair service to set up an appointment. Light the wick with your match and adjust the size of the flame to the recommended settings for your unit.Įven though it is easy, it can be annoying to do this every time you want to turn the heater on.First, open the body of the heater and use the burner knob to raise the burn chamber and wick.Even though it is simple to do, you will always want to be safe while handling fire. If you are in a pinch and need the heater on right away, you can always try lighting it manually until someone can fix the ignition problems.Īll you will need is a match. If you have followed all of those steps, and your heater is still not lighting, then you will want to hire a professional to fix the issue. Drain all fuel from the tank and take out the wick and replace it. Once you have done that, lower the wick until it is just touching the igniter plug.If replacing the batteries does not help, then you can try replacing the actual igniter plug to fix it. You will only need to do this if the ignitor plug is not glowing when you press its button. If that did not help, you can try replacing the batteries for the igniter.If it seems low, be sure to refill the tank with kerosene. You can do this by removing the fuel tank’s cap and checking. First, you will want to check that it has enough fuel and that the kerosene has not gone bad.There could be a few different reasons as to why your kerosene heater will not light. You might need to find a replacement kerosene heater wick if it is too short to burn.Ĭheck Price on Amazon Heater Will Not Light Note: if your kerosene heater is going out frequently, it could also be a sign that your wick is not raised high enough. Remove the knob used to adjust the wick, then when you reassemble it, you should be able to adjust the wick with the knob again.Remove the screws that hold the cabinet in place with a screwdriver, then you can lift its handle to take it off.In some cases, you are going to have to change the wick. If you were using it, you will want to wait until the unit cools down before you touch it. There are a few steps you can take to fix the issue. When the wick is consistently too low, it is a sign that it has slipped too far down into the unit. Common Kerosene Heater Problems Wick Will not Raise